DM 500S satfoolspecial
DreamBox 500S (Satellite Receiver)
Exclusive UK plug and Power switch Button in the Back
DreamBox 500S (Satellite Receiver)
Exclusive UK plug and Power switch Button in the Back
Exclusive UK plug and Power switch Button in the Back

250 MHz IBM PowerPC Processor (350 Mips)
2 LED status
Linux Operating System
Full automatic service scan
Supports directly bouquet-lists (indirect unlimited)
Supports multiple LNB-Switching control (supports DiSEqC)
1 x Smartcard-Reader
Unlimited channel lists for TV/Radio
SPDI/F interface for digital bit stream out (AC-3 / DTS)
MPEG2 Hardware decoding
Channel-change time < 1 second
Fully adaptable OSD in many languages (skin-support)
100Mbit full duplex Ethernet Interface
Supports EPG (electronic program guide)
1 x Scart-interfaces (fully controlled by software)
Video decoder:
Video Compression MPEG-2 and MPEG-1 compatible
Video Standard PAL and NTSC
Video Formats 4:3 / 16:9
Footage 16:9, automatic assimilation for 16:9 TV-Device (over Scart)
Letterbox percolating for 4:3 TV-Device Audio decoder:
Audiokompression MPEG-1 & MPEG-2 Layer I and II
Audio Mode Dual (main/sub), Stereo
Frequency: 32 kHz, 44.1 kHz, 48 kHz, 16 kHz, 22.05 kHz, 24 kHz
Video parameter:
Input Level FBAS 1 Vss +/- 0.3 dB on 75 Ohm
Teletext filter in conformity with ETS 300 472 Standard
TV-Scart:
Output: FBAS,RGB,S-VHS over OSD selectable
DBS-Tuner:
Frequency Range 950 .. 2150 MHz
Signal Level - 65 dBm .. - 25 dBm
Signal-to-Noise Level 12 dB max.
DBS-Tuner Input Connector F-Type female
Input Impedance 75 Ohm
AFC +/- 3 MHz
Demodulation Shaped QPSK
Input Symbol rate 2 .. 45 Mbaud/s, SCPC / MCPC
FEC Viterbi and Reed-Solomon
Viterbirate 1/2, 2/3, 3/4, 5/6, 7/8, automatic assimilation
Roll-off Factor 35 %
Demultiplexing according ISO 13818-1
Ethernet:
100 MBit compatible, bi-directional interface
Function Update of Firmware and Reprogramming
LNB Power and polarisation:
LNB Current 500mA max. ; short-circuit-proof
LNB Voltage vertical < 14V without load, > 11,5V at 400mA
LNB Voltage horizontal < 20V without load, > 17,3V at 400mA
LNB shut-off at Standby-Mode
Count of active satellite position:
DiSEqC 1.0/1.2 SAT POSITION / SAT OPTION
DiSEqC - Rotor Control
Output digital:
Output Level 0,5 Vss on 75 Ohm
Sampled Data Filtering 32 kHz, 44.1 kHz, 48 kHz
S/PDIF-Output optical (AC3)
Output analogue:
Output Level L/R 0,5 Vss on 600 Ohm
THD > 60 dB (1 kHz)
Crosstalk < -65 dB
Serial Interface RS 232:
Type RS232 bidirectional
Bit rate 115,2 kBit/s max.
Plug Connector SUB-D-9
Function Update of Firmware and Reprogramming
Power consumption:
< 10W / 12V
Input voltage:
DC12V,alternating acurrent +/- 15%
Extern power supply:
Input:
110-240V AC / 50-60Hz / 0,6A
Output:
12V = / 1A
Others:
Ambient Temperature +15°C...+35°C
Humidity < 80%
DM500S + Homeplug set - Satfool`s Special Deal
£105.00 View Add to cart
******UK Type****** High-Speed Powerline adapter with Ethernet interface for fast data transfer...
£55.00 View Add to cart
*****European Type**** High-Speed Powerline adapter with Ethernet interface for fast data...
£50.00 View Add to cart
For communication between a PC and a Satellite receiver for new firmware (Operating software) or...
£2.00 View Add to cart
10m Cat5.e Ethernet Cable (Gray)
£6.50 View Add to cart
5m Cat5.e Ethernet Cable (Blue)
£4.00 View Add to cart
£2.50 View Add to cart
The DiSEqC switch will enable the user to select one LNB signal between 4 different LNBs of any...
£12.00 View Add to cart
Inline Satellite Amplifier 20dB
Inline Satellite Amplifier/Amp/Weak...
£8.00 View Add to cart
No customer comments for the moment.
Only registered user can post a new comment.
No products
Shipping
£0.00
Total
£0.00




